Use the Info>Mechanica Mass Properties command to view the Mechanica mass and moments of inertia for your model. Mechanica calculates mass properties for your model based on material properties, so you must assign a material to your model before you can view mass properties. This command is not available in FEM mode.

When you select this command in assembly mode, Mechanica prompts you to select a body. In part or assembly mode, Mechanica also prompts you to select or create a reference point or accept the body's center of mass as the reference point.

When you complete your selections, the Pro/ENGINEER embedded browser opens with the following information:

• Coordinates of the selected reference point in the UCS

• Mass of the selected body

• Center of mass relative to the selected reference point in the UCS

• Moments and products of inertia about the reference point and relative to UCS

• Principal moments of inertia about the center of mass and principal axes relative to WCS

返回pro/e文章列表>>>