Use this tab on the Simulation Display dialog box to control visibilities of load and constraint icons. Two sections of the tab list icons available in Structure and Thermal. Although the two products do not share the icons, each having its own set, all icons on the tab are accessible from both products.
By default, all Structure icons are set to be visible and all Thermal icons are invisible if you are working in Structure. In Thermal, all Thermal icons are set to be on and all Structure icons are off. If you want to change these settings, use the Clear All or Select All buttons, or make individual selections in the Structure or Thermal section of the tab.
Structure
-
Constraints
-
Cyclic Symmetry
-
Forces/Moments
-
Pressures
-
Bearing Loads
-
Gravity Load
|
-
Centrifugal Load
-
Global Temperature
-
Structural Temperature
-
External Temperature
-
MEC/T
-
Temperature
|
Thermal
-
Prescribed Temperatures
-
Cyclic Symmetry
-
Convection Conditions
|
-
Radiation
-
Heat Loads
-
Volume Heat
|
To obtain more information about icons,see Icons Used in Mechanica.
Another method you can use to manage visibilities is layers. You can place varying combinations of loads and constraints along with the modeling entities on a layer. Then, you can blank the layer to remove from view the entities on it, or show the layer to restore the layer entities to view. For more information on layers, search the Basic Pro/ENGINEER functional area of the Pro/ENGINEER Help Center.
返回pro/e文章列表>>>
|